Figure 5-1 System Power On/Stby (Front Panel) - Sun Microsystems Netra T4 AC100 Service And System Reference Manual

5.3.1.1 Netra T4 AC100 System
1. Plug the AC power cord into the appliance inlet on the PSU and into the mains
supply.
2. Set the front panel ON/STBY system switch to the ON
the system starts to power up, or use the LOMlite2 poweron command or OBP
poweron command.
FIGURE 5-1
5.3.1.2 Netra T4 DC100 System
1. Insert both DC input connectors.
2. Close both DC circuit breakers.
3. Momentarily set the front panel ON/STBY system switch to the ON
and hold it until the system starts to power up.
ON
STBY
System Power On/STBY (Front Panel)
position and hold it until
SYSTEM
ALARM 1
ALARM 2
Chapter 5 Before Servicing the System
position
5-3