Replacing The Filter - Sun Microsystems Netra T4 AC100 Service And System Reference Manual

5. Insert the locating tabs one side of the mesh screen into the corresponding slots
on the fascia.
6. Carefully swing the other side down until the catches on the screen engage with
the fascia.
7. Re-attach the fascia to the system chassis.
See Section 5.7.2, "Fitting the Front Fascia" on page 5-11.
5.8.2

Replacing the Filter

1. If not already removed, detach the front fascia and place it on a workbench away
from the immediate vicinity of the system.
See Section 5.7.1, "Removing the Front Fascia" on page 5-11.
2. Release the two clips securing the filter retainer and lift it from the fascia.
3. Remove the filter and carefully dispose of it.
4. Clean the fascia to remove any remaining dust.
5. Insert a new filter and secure it with the retainer.
6. Re-attach the fascia to the system chassis.
See Section 5.7.2, "Fitting the Front Fascia" on page 5-11.
Chapter 5 Before Servicing the System 5-13