Installing An Unmirrored Root Disk; Fiber Channel Backplane And Drive Bay - Sun Microsystems Netra T4 AC100 Service And System Reference Manual

6. Holding the disk by the handle, slide the disk drive out of the bay.
Support the weight of the drive with your other hand to avoid unnecessary pressure
on the drive handle.
7. Place the disk drive on an antistatic mat.
8.1.6

Installing an Unmirrored Root Disk

1. Perform the steps listed in Section 8.1.4, "Preparing to Remove an Unmirrored
Root Disk" on page 8-5, as required.
2. Align the disk drive with the slot in the drive bay.
3. Slide the disk drive into the drive bay until it makes contact with the FC-AL
backplane connector.
Do not force it home.
4. Lock the drive in the bay by pressing on the drive handle until the drive latch
closes.
This action engages the drive with the FC-AL backplane connector.
5. Refit the front fascia.
See Section 5.7.2, "Fitting the Front Fascia" on page 5-11.
6. Perform a reconfiguration boot by typing:
ok boot -r
8.2

Fiber Channel Backplane and Drive Bay

The FC-AL backplane and drive bay assembly is located at the front of the chassis, to
the left of the CPU fan, and houses the two internal disk drives. There are one
connector, one power connector and one I2C connector to the backplane, which is
mounted on the rear of the drive bay (see
8-6 Netra T4 AC100/DC100 Service and System Reference Manual • August 2001
).
FIGURE 8-2