Removing The Battery; Installing The Battery; Figure 9-6 Battery Location - Sun Microsystems Netra T4 AC100 Service And System Reference Manual

2. If the system is running, shut it down and remove the power.
See Section 5.3.2, "Powering Off the System" on page 5-4.
3. Remove the top access cover.
See Section 5.6.2, "Removing the Top Access Cover" on page 5-9.
9.4.2

Removing the Battery

1. Perform the steps listed in Section 9.4.1, "Preparation" on page 9-12 as required.
2. Locate the battery on the motherboard.
See
FIGURE 9-9
3. Carefully lift the battery retaining clip with a small screwdriver.
4. Carefully slide the battery out of its socket and remove it from the system.
FIGURE 9-6
9.4.3

Installing the Battery

Note – Install the new battery with the plus (+) side up.
1. Hold the battery retaining clip up and slide the battery into its socket.
2. Install the CPU shroud cover.
3. Refit the top access cover.
See Section 5.6.3, "Fitting the Top Access Cover" on page 5-9.
4. Reset the time of day and date.
Battery Location
Chapter 9 Motherboard and Component Replacement 9-13