Preparation; Removing A Pci Card; Installing A Pci Card - Sun Microsystems Netra T4 AC100 Service And System Reference Manual

9.1.1

Preparation

Before proceeding to remove or fit a PCI card, carry out the following:
1. Initiate antistatic precautions.
See Section 5.5, "Antistatic Precautions" on page 5-5.
2. If the system is running, shut it down and remove the power.
See Section 5.3.2, "Powering Off the System" on page 5-4.
3. Remove the top access cover.
See Section 5.6.2, "Removing the Top Access Cover" on page 5-9.
9.1.2

Removing a PCI Card

1. Perform the steps listed in Section 9.1.1, "Preparation" on page 9-3.
2. Disconnect all external cables connected to the PCI card.
3. Disconnect any internal cables connected to the PCI card.
4. Remove the fixing screw securing the card to the rear of the chassis.
5. Ease the card from its slot.
6. Place the card on the antistatic mat.
7. If you are not replacing the card, fit a blanking plate to the rear panel of the
chassis and secure it with the fixing screw.
8. Refit the top access cover.
See Section 5.6.3, "Fitting the Top Access Cover" on page 5-9.
9.1.3

Installing a PCI Card

1. Perform the steps listed in Section 9.1.1, "Preparation" on page 9-3.
2. Locate a vacant PCI slot.
If your PCI card is a 66 Mhz card, you must use slot 1.
3. If the slot is protected by a blanking plate, remove the fixing screw and the plate.
4. Gently push the card into the connector, applying even pressure at both ends of
the card.
Chapter 9 Motherboard and Component Replacement 9-3