Tool Requirements - Sun Microsystems Netra T4 AC100 Service And System Reference Manual

Hide thumbs Also See for Netra T4 AC100:
Table of Contents

Advertisement

C
A P P E N D I X

Tool Requirements

This appendix lists the tools you will require to service the Netra T4 system:
Phillips No. 1 screwdriver, 10 cm (4 in.)
Phillips No. 2 screwdriver, 15 cm (6 in.)
Phillips No. 2 screwdriver, stubby
6 mm (0.25 in.) flat blade screwdriver, 10 cm (4 in.)
Antistatic wrist strap
Antistatic mat
Long-nose pliers
Digital voltage meter (DVM)
Torque tool (calibrated to 5 lbf-in., 3 mm square drive)
Place components sensitive to electrostatic discharge (ESD), such as system boards,
disk drives and memory modules on an antistatic mat.
1. Located inside the system , at the front of the chassis on the left-hand side panel.
1
C-1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Netra T4 AC100 and is the answer not in the manual?

This manual is also suitable for:

Netra t4 dc100

Table of Contents