Lomlite 2 Leds; Table 1-2 Lomlite2 Status Led Functions - Sun Microsystems Netra T4 AC100 Service And System Reference Manual

TABLE 1-1
LED
Disk1 Active
Disk1 OK to
Remove
Disk1 Fault
1. These LEDs are duplicated on the LOMlite2 card face plate (see Section 1.4.2, "LOMlite 2 LEDs" on page 1-8).
2. Lower the front fascia to view these LEDs.
1.4.2

LOMlite 2 LEDs

The LOMlite2 status LEDs, which mirror the alarm status and power LEDs on the
front panel, are located on the rear of the system, between the LOMlite2 DB-15
alarms relay port and RJ45 serial port as shown in
TABLE 1-2
LED
Alarm 1
Alarm 2
Fault
System
1-8 Netra T4 AC100/DC100 Service and System Reference Manual • August 2001
Front Panel System LED Functions (Continued)
Icon/Legend
2
2
2
LOMlite2 Status LED Functions
Icon/Legend
1
2
SYS
Color Function
Green Illuminated when Disk1 is active
Blue Illuminated, in response to a user request,
when disk1 can be removed safely without
affecting the system operation
Amber Illuminated when the system has identified a
fault in Disk1
FIGURE 1-3
Color Function
Amber Illuminated when user-defined Alarm 1 is
asserted
Amber Illuminated when user-defined Alarm 2 is
asserted
Amber Driven by the LOMlite 2 card and
illuminated when a system fault condition
exists
Green Illuminated when Solaris is running and the
LOMlite2 driver is installed
Off while the system is powering up
Reset by watchdog timeout, assertion of user-
defined Alarm 3
.