Sun Microsystems Netra T4 AC100 Service And System Reference Manual page 105

10. Refit the PSU fan assembly.
See Section 7.1.3, "Installing the PSU Fans Assembly" on page 7-4.
11. Refit the CPU fan assembly.
See Section 7.2.3, "Installing the CPU Fan Assembly" on page 7-7.
12. Reconnect the I2C ribbon cable from J3604 on the SCCR board to J4 on the PDB
by inserting the connector in the socket and closing the retaining lugs at each end
of the socket.
13. Reconnect the small white 14-way power cable from J3603 on the motherboard to
J3 on the PDB by inserting the connector until the central locking lug at the back
of the connector clicks into place.
14. Reconnect the large black 14-way power cable from J3604 on the motherboard to
J2 on the PDB by inserting the connector until the two locking lugs at each end of
the connector click into place.
15. Refit the CPU shroud.
See Section 9.2.3, "Installing a CPU Module" on page 9-7.
16. Refit the FC-AL disk drive assembly.
See Section 8.2.3, "Installing the FC-AL Backplane and Drive Bay" on page 8-9.
17. Refit the RMM assembly.
See Section 8.3.3, "Installing a Removable Media Module" on page 8-12.
18. Engage the PSU connector with the PDB by performing Step 4 through Step 6 of
the PSU fitting procedure.
See Section 6.1.3, "Installing the PSU" on page 6-3.
19. Refit the top access cover.
See Section 5.6.3, "Fitting the Top Access Cover" on page 5-9.
Chapter 6 Power Subassemblies 6-7