Using The Setup Wizard; Starting The Wizard - Cisco RV 120W Administration Manual

Introduction
Connecting the Equipment
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco RV 120W Administration Guide

Using the Setup Wizard

Follow these steps to use the Cisco RV 120W Setup Wizard. The Setup Wizard
displays on-screen instructions that guide you through the installation, but you may
find it useful to refer to this document during installation.
You must connect one PC with an Ethernet cable for the purpose of the initial
configuration. After you complete the initial configuration, administrative tasks can
be performed using a wireless connection.

Starting the Wizard

Make sure that all of the network hardware is powered off, including the
Cisco RV 120W and cable or DSL modem.
Insert the CD that shipped with the Cisco RV 120W into the PC you are using to
configure the Cisco RV 120W. The Setup Wizard automatically begins.
Click Start to begin the installation.
Click the check box to accept the software license agreement and click Next.
The Setup Wizard verifies the network adapter on your PC is functional. If you
receive an error, view your PC's network connections to make sure the network
adapter is working and click Back to test the connection again.
Next:
• If your network adapter is functional and you have not yet connected your
hardware, the Install Router window appears. (See
Hardware, page
• If your network adapter is functional, you have already connected your
hardware, and your Internet connection has been detected, the Secure Your
Router Settings window appears. (See
9.)
Connecting Your
Configuring Security, page
1
14.)
8