Path Jitter Operation Configuration Example - H3C SR6600-X Configuration Manual

NQA entry (admin admin, tag test1) history records:
Index
1
The output shows that the response time of the DLSw device is 19 milliseconds.

Path jitter operation configuration example

Network requirements
As shown in
A to Device B and Device C.
Figure 19 Network diagram
Configuration procedure
# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other. (Details not
shown.)
# Use the ip ttl-expires enable command on Device B and use the ip unreachables enable command on
Device C.
# Create a path jitter operation.
<DeviceA> system-view
[DeviceA] nqa entry admin test1
[DeviceA-nqa-admin-test1] type path-jitter
# Specify 10.2.2.2 as the destination IP address of ICMP echo requests.
[DeviceA-nqa-admin-test1-path-jitter] destination ip 10.2.2.2
# Configure the path jitter operation to repeat at an interval of 10000 milliseconds.
[DeviceA-nqa-admin-test1-path-jitter] frequency 10000
[DeviceA-nqa-admin-test1-path-jitter] quit
# Start the path jitter operation.
[DeviceA] nqa schedule admin test1 start-time now lifetime forever
# After the path jitter operation runs for a period of time, stop the operation.
[DeviceA] undo nqa schedule admin test1
# Display the most recent result of the path jitter operation.
[DeviceA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Hop IP 10.1.1.2
Basic Results
Send operation times: 10
Min/Max/Average round trip time: 9/21/14
Square-Sum of round trip time: 2419
Response Status
19 Succeeded
Figure 19, configure a path jitter operation to test the round trip time and jitters from Device
Time
2011-11-22 10:40:27.7
Receive response times: 10
56