H3C SR6600-X Configuration Manual page 145

[DeviceB] ptp profile 1588v2
# Specify the clock node type as E2ETC.
[DeviceB] ptp mode e2etc
# Specify the system time source as PTP.
[DeviceB] clock protocol ptp
# Enable PTP for GigabitEthernet 2/0/1.
[DeviceB] interface gigabitethernet 2/0/1
[DeviceB-GigabitEthernet2/0/1] ptp enable
[DeviceB-GigabitEthernet2/0/1] quit
# Enable PTP for GigabitEthernet 2/0/2.
[DeviceB] interface gigabitethernet 2/0/2
[DeviceB-GigabitEthernet2/0/2] ptp enable
[DeviceB-GigabitEthernet2/0/2] quit
3. Configure Device C:
# Specify the PTP standard as IEEE 1588 version 2.
<DeviceC> system-view
[DeviceC] ptp profile 1588v2
# Specify the clock node type as OC.
[DeviceC] ptp mode oc
# Specify the system time source as PTP.
[DeviceC] clock protocol ptp
# Enable PTP on GigabitEthernet 2/0/1.
[DeviceC] interface gigabitethernet 2/0/1
[DeviceC-GigabitEthernet2/0/1] ptp enable
[DeviceC-GigabitEthernet2/0/1] quit
4. Verify the configuration:
When the network is stable, perform the following tasks:
Use the display ptp clock command to display PTP clock information.
Use the display ptp interface brief command to display brief PTP statistics on an interface.
# Display PTP clock information on Device A.
[DeviceA] display ptp clock
PTP profile
PTP mode
Slave only
Clock ID
Clock type
Clock domain
Number of PTP ports : 1
Priority1 : 128
Priority2 : 128
Clock quality :
Class
Accuracy
Offset (log variance) : 65535
Offset from master : 0 (ns)
: IEEE 1588 Version 2
: OC
: No
: 000FE2-FFFE-FF0000
: Local
: 0
: 248
: 254
131