Voice Operation Configuration Example - H3C SR6600-X Configuration Manual

# Display the most recent result of the UDP tracert operation.
[DeviceA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Send operation times: 6
Min/Max/Average round trip time: 1/1/1
Square-Sum of round trip time: 1
Last succeeded probe time: 2013-09-09 14:46:06.2
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to internal error: 0
Failures due to other errors: 0
UDP-tracert results:
TTL
1
2
# Display the history records of the UDP tracert operation.
[DeviceA] display nqa history admin test1
NQA entry (admin admin, tag test1) history records:
Index
1
1
1
1
1
1

Voice operation configuration example

Network requirements
As shown in
Figure 17 Network diagram
Configuration procedure
Assign each interface an IP address. (Details not shown.)
1.
2. Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
3. Configure Device B:
# Enable the NQA server.
<DeviceB> system-view
[DeviceB] nqa server enable
Hop IP
3.1.1.1
10.2.2.2
TTL Response
2 2
2 1
2 2
1 1
1 2
1 1
Figure 17, configure a voice operation to test jitters between Device A and Device B.
Receive response times: 6
Time
2013-09-09 14:46:03.2
2013-09-09 14:46:06.2
Hop IP Status
10.2.2.2 Succeeded
10.2.2.2 Succeeded
10.2.2.2 Succeeded
3.1.1.1 Succeeded
3.1.1.1 Succeeded
3.1.1.1 Succeeded
52
Time
2013-09-09 14:46:06.2
2013-09-09 14:46:05.2
2013-09-09 14:46:04.2
2013-09-09 14:46:03.2
2013-09-09 14:46:02.2
2013-09-09 14:46:01.2