Icmp Template Configuration Example - H3C SR6600-X Configuration Manual

127.0.0.1/32
127.255.255.255/32
224.0.0.0/4
224.0.0.0/24
255.255.255.255/32
The output shows that the static route does not exist, and the status of the track entry is negative.

ICMP template configuration example

Network requirements
As shown in
from Device A to Device B.
Figure 21 Network diagram
Configuration procedure
# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other. (Details not
shown.)
# Create ICMP template icmp.
<DeviceA> system-view
[DeviceA] nqa template icmp icmp
# Specify 10.2.2.2 as the destination IP address of ICMP echo requests.
[DeviceA-nqatplt-icmp-icmp] destination ip 10.2.2.2
# Set the probe timeout time for the ICMP echo operation to 500 milliseconds.
[DeviceA-nqatplt-icmp-icmp] probe timeout 500
# Configure the ICMP echo operation to repeat at an interval of 3000 milliseconds.
[DeviceA-nqatplt-icmp-icmp] frequency 3000
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Figure 21, configure an ICMP template for a feature to perform the ICMP echo operation
0 127.0.0.1
0 127.0.0.1
0 0.0.0.0
0 0.0.0.0
0 127.0.0.1
60
InLoop0
InLoop0
NULL0
NULL0
InLoop0