Configuring The Http Operation - H3C SR6600-X Configuration Manual

Use a small file for the FTP operation. A big file might result in transfer failure because of timeout,
•
or might affect other services for occupying much network bandwidth.
To configure the FTP operation:
Step
1. Enter system view.
2. Create an NQA operation
and enter NQA operation
view.
3. Specify the FTP type and
enter its view.
4. Specify the URL of the
destination FTP server.
5. (Optional.) Specify the
source IP address of FTP
request packets.
6. Specify the FTP operation
type.
7. Specify an FTP login
username.
8. Specify an FTP login
password.
9. (Optional.) Specify the
name of a file to be
transferred.
10. Set the data transmission
mode.

Configuring the HTTP operation

An HTTP operation measures the time for the NQA client to obtain data from an HTTP server.
To configure an HTTP operation:
Step
1. Enter system view.
Command
system-view
nqa entry admin-name
operation-tag
type ftp
url url
source ip ip-address
operation { get | put }
username username
password { cipher | simple }
password
filename file-name
mode { active | passive }
Command
system-view
15
Remarks
N/A
By default, no NQA operation is created.
N/A
By default, no URL is specified for the
destination FTP server.
Enter the URL in one of the following
formats:
•
ftp://host/filename.
•
ftp://host:port/filename.
When you perform the get operation, the
file name is required.
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no FTP
requests can be sent out.
By default, the FTP operation type is get,
which means obtaining files from the FTP
server.
By default, no FTP login username is
configured.
By default, no FTP login password is
configured.
By default, no file is specified.
This step is required if you perform the put
operation.
The default mode is active.
Remarks
N/A