Ptp Configuration Example (Ieee 1588 Version 2, Ieee 802.3/Ethernet Encapsulation) - H3C SR6600-X Configuration Manual

Task
Display PTP statistics.
Display PTP clock time properties.
Clear PTP statistics.
PTP configuration example (IEEE 1588 version 2,
IEEE 802.3/Ethernet encapsulation)
Network requirements
As shown in
Configure all devices to use PTP standard IEEE 1588 version 2.
•
• Configure PTP messages to be encapsulated in IEEE 802.3/Ethernet packets.
Configure the clock node type of Device A and Device C as OC, and that of Device B as E2ETC.
•
All clock nodes elect a GM through BMC based on their respective default GM attributes.
Figure 45 Network diagram
OC
Device A
Configuration procedure
1. Configure Device A:
# Specify the PTP standard as IEEE 1588 version 2.
<DeviceA> system-view
[DeviceA] ptp profile 1588v2
# Specify the clock node type as OC.
[DeviceA] ptp mode oc
# Specify the system time source as PTP.
[DeviceA] clock protocol ptp
# Enable PTP on GigabitEthernet 2/0/1.
[DeviceA] interface gigabitethernet 2/0/1
[DeviceA-GigabitEthernet2/0/1] ptp enable
[DeviceA-GigabitEthernet2/0/1] quit
2. Configure Device B:
# Specify the PTP standard as IEEE 1588 version 2.
<DeviceB> system-view
Figure 45, a PTP domain contains Device A, Device B, and Device C.
E2ETC
GE2/0/1 GE2/0/1
Device B
PTP domain
Command
display ptp statistics [ interface interface-type
interface-number ]
display ptp time-property
reset ptp statistics [ interface interface-type
interface-number ]
OC
GE2/0/2 GE2/0/1
Device C
130