H3C SR6600-X Configuration Manual page 37

Step
4. Specify the destination
address of voice packets.
5. Specify the destination port of
voice packets.
6. (Optional.) Specify the codec
type.
7. (Optional.) Specify the
advantage factor for
calculating MOS and ICPIF
values.
8. (Optional.) Specify the source
IP address of voice packets.
9. (Optional.) Specify the source
port number of voice packets.
10. (Optional.) Specify the
payload size in each voice
packet.
(Optional.) Specify the string
11.
to be filled in the payload of
each voice packet.
12. (Optional.) Specify the
number of voice packets to be
sent in a voice probe.
13. (Optional.) Specify the
interval for sending voice
packets.
14. (Optional.) Specify how long
the NQA client waits for a
response from the server
before it regards the response
times out.
NOTE:
Use the display nqa result or display nqa statistics command to verify the voice operation. The display
nqa history command does not display the voice operation results or statistics.
Command
destination ip ip-address
destination port port-number
codec-type { g711a | g711u |
g729a }
advantage-factor factor
source ip ip-address
source port port-number
data-size size
data-fill string
probe packet-number
packet-number
probe packet-interval
packet-interval
probe packet-timeout
packet-timeout
23
Remarks
By default, no destination IP address
is configured.
The destination IP address must be
the same as the IP address of the
listening service on the NQA server.
By default, no destination port
number is configured.
The destination port number must be
the same as the port number of the
listening service on the NQA server.
By default, the codec type is G.711
A-law.
By default, the advantage factor is 0.
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
voice packets can be sent out.
By default, no source port number is
specified.
By default, the voice packet size
varies by codec type. The default
packet size is 172 bytes for
G.711A-law and G.711 μ-law codec
type, and 32 bytes for G.729 A-law
codec type.
The default setting is the hexadecimal
number
00010203040506070809.
The default setting is 1000.
The default setting is 20 milliseconds.
The default setting is 5000
milliseconds.