Displaying And Maintaining Eaa Settings; Eaa Configuration Examples; Cli-Defined Policy Configuration Example - H3C SR6600-X Configuration Manual

Displaying and maintaining EAA settings

Execute display commands in any view.
Task
Display user-defined EAA environment variables.
Display EAA monitor policies.

EAA configuration examples

CLI-defined policy configuration example

Network requirements
Configure a policy from the CLI to monitor the event that occurs when a question mark (?) is entered at
the command line that contains letters and digits.
When the event occurs, the system executes the command and sends the log message "hello world" to
the information center.
Configuration procedure
# Create CLI-defined policy test and enter its view.
<Sysname> system-view
[Sysname] rtm cli-policy test
# Add a CLI event that occurs when a question mark (?) is entered at any command line that contains
letters and digits.
[Sysname-rtm-test] event cli async mode help pattern [a-zA-Z0-9]
# Add an action that sends the message "hello world" with a priority of 4 from the logging facility local3
when the event occurs.
[Sysname-rtm-test] action 0 syslog priority 4 facility local3 msg "hello world"
# Add an action that enters system view when the event occurs.
[Sysname-rtm-test] action 2 cli system-view
# Add an action that creates VLAN 2 when the event occurs.
[Sysname-rtm-test] action 3 cli vlan 2
# Set the policy runtime to 2000 seconds. The system stops executing the policy and displays an
execution failure message if it fails to complete policy execution within 2000 seconds.
[Sysname-rtm-test] running-time 2000
# Specify the network-admin user role for executing the policy.
[Sysname-rtm-test] user-role network-admin
# Enable the policy.
[Sysname-rtm-test] commit
Command
display rtm environment [ var-name ]
display rtm policy { active | registered [ verbose ] }
[ policy-name ]
190