Snmpv1/Snmpv2C Configuration Example; Network Requirements; Configuration Procedure - H3C SR6600-X Configuration Manual

SNMPv1/SNMPv2c configuration example

The SNMPv1 configuration procedure is the same as the SNMPv2c configuration procedure. This
example uses SNMPv1, and is available only for high encryption in non-FIPS mode.

Network requirements

As shown in
the agent automatically sends notifications to report events to the NMS.
Figure 53 Network diagram

Configuration procedure

1. Configure the SNMP agent:
# Configure the IP address of the agent and make sure the agent and the NMS can reach each
other. (Details not shown.)
# Specify SNMPv1, and create the read-only community public and the read and write community
private.
<Agent> system-view
[Agent] snmp-agent sys-info version v1
[Agent] snmp-agent community read public
[Agent] snmp-agent community write private
# Configure contact and physical location information for the agent.
[Agent] snmp-agent sys-info contact Mr.Wang-Tel:3306
[Agent] snmp-agent sys-info location telephone-closet,3rd-floor
# Enable SNMP notifications, specify the NMS at 1.1.1.2 as an SNMP trap destination, and use
public as the community name. (To make sure the NMS can receive traps, specify the same SNMP
version in the snmp-agent target-host command as is configured on the NMS.)
[Agent] snmp-agent trap enable
[Agent] snmp-agent target-host trap address udp-domain 1.1.1.2 params securityname
public v1
Configure the SNMP NMS:
2.
Specify SNMPv1.
Create the read-only community public, and create the read and write community private.
Configure timeout time and maximum number of retries as needed.
For information about configuring the NMS, see the NMS manual.
NOTE:
The SNMP settings on the agent and the NMS must match.
Figure 53, the NMS (1.1.1.2/24) uses SNMPv1 to manage the SNMP agent (1.1.1.1/24), and
167