H3C SR6600-X Configuration Manual page 132

Tasks at a glance
The PTP standard is IEEE 1588 version 2:
(Required.) Specifying a clock node type
(Optional.) Specifying a PTP domain
(Optional.) Configuring an OC to operate only as a member clock
(Optional.) Configuring ToD input or output
(Optional.) Configuring the role of a PTP port
(Optional.) Configuring the mode for carrying timestamps
(Optional.) Specifying a delay measurement mechanism for a BC or an OC
(Optional.) Configuring the port type for a TC+OC
(Optional.) Configuring the interval for sending announce messages
(Optional.) Specifying the number of announcement intervals before the receiving node stops receiving
announce messages
(Optional.) Configuring the interval for sending Pdelay_Req messages
(Optional.) Configuring the interval for sending Sync messages
(Optional.) Configuring the minimum interval for sending Delay_Req messages
(Optional.) Configuring the MAC address for non-pdelay messages
(Optional.) Specifying the protocol for encapsulating PTP messages as UDP (IPv4)
(Optional.) Configuring the source IP address for multicast PTP message transmission over UDP (IPv4)
(Optional.) Configuring the destination IP address for unicast PTP message transmission over UDP (IPv4)
(Optional.) Configuring the delay correction value
(Optional.) Configuring the cumulative offset between the UTC and TAI
(Optional.) Configuring the correction date of the UTC
(Optional.) Configuring ToD clock parameters
(Optional.) Configuring a priority for a clock
(Optional.) Setting a DSCP value for PTP messages transmitted over UDP (IPv4)
(Optional.) Specifying the system time source as PTP
(Required.) Enabling PTP on a port
118