Verifying The Configuration; Snmpv3 Configuration Example; Network Requirements; Configuration Procedure - H3C SR6600-X Configuration Manual

Verifying the configuration

# Try to get the MTU value of NULL0 interface from the agent. The attempt succeeds.
Send request to 1.1.1.1/161 ...
Protocol version: SNMPv1
Operation: Get
Request binding:
1: 1.3.6.1.2.1.2.2.1.4.135471
Response binding:
1: Oid=ifMtu.135471 Syntax=INT Value=1500
Get finished
# Use a wrong community name to get the value of a MIB node on the agent. You can see an
authentication failure trap on the NMS.
1.1.1.1/2934 V1 Trap = authenticationFailure
SNMP Version = V1
Community = public
Command = Trap
Enterprise = 1.3.6.1.4.1.43.1.16.4.3.50
GenericID = 4
SpecificID = 0
Time Stamp = 8:35:25.68

SNMPv3 configuration example

Network requirements

As shown in
of the agent (1.1.1.1/24). The agent automatically sends notifications to report events to the NMS. The
default UDP port 162 is used for SNMP notifications.
The NMS and the agent perform authentication when they establish an SNMP session. The
authentication algorithm is SHA- 1 and the authentication key is 123456TESTauth&!. The NMS and the
agent also encrypt the SNMP packets between them by using the AES algorithm and the privacy key
123456TESTencr&!.
Figure 54 Network diagram

Configuration procedure

Configuring SNMPv3 in RBAC mode
1. Configure the agent:
Figure 54, the NMS (1.1.1.2/24) uses SNMPv3 to monitor and manage the interface status
168