H3C SR6600-X Configuration Manual page 151

[DeviceC] clock protocol ptp
# On GigabitEthernet 2/0/1, configure the destination IP address for unicast PTP message
transmission over UDP (IPv4), and enable PTP.
[DeviceC] interface gigabitethernet 2/0/1
[DeviceC-GigabitEthernet2/0/1] ptp transport-protocol udp
[DeviceC-GigabitEthernet2/0/1] ptp unicast-destination 11.10.10.2
[DeviceC-GigabitEthernet2/0/1] ptp enable
[DeviceC-GigabitEthernet2/0/1] quit
5. Verify the configuration:
When the network is stable, perform the following tasks:
Use the display ptp clock command to display PTP clock information.
Use the display ptp interface brief command to display brief PTP statistics on an interface.
# Display PTP clock information on Device A.
[DeviceA] display ptp clock
PTP profile
PTP mode
Slave only
Clock ID
Clock type
Clock domain
Number of PTP ports : 1
Priority1 : 0
Priority2 : 128
Clock quality :
Class
Accuracy
Offset (log variance) : 65535
Offset from master : 0 (ns)
Mean path delay
Steps removed
Local clock time
# Display brief PTP statistics on Device A.
[DeviceA] display ptp interface brief
Name State
GE2/0/1 Master
# Display PTP clock information on Device B.
[DeviceB] display ptp clock
PTP profile
PTP mode
Slave only
Clock ID
Clock type
Clock domain
Number of PTP ports : 2
Priority1 : 128
Priority2 : 128
Clock quality :
: IEEE 1588 Version 2
: OC
: No
: 000FE2-FFFE-FF0000
: ToD0
: 0
: 6
: 32
: 0 (ns)
: 0
: Sun Jan 15 20:57:29 2011
Delay mechanism
E2E
: IEEE 1588 Version 2
: E2ETC
: No
: 000FE2-FFFE-FF0001
: Local
: 0
137
Clock step Asymmetry correction
Two 0