H3C SR6600-X Configuration Manual page 235

Router A performs NetStream aggregation in the modes of AS, protocol-port, source-prefix,
•
destination-prefix, and prefix.
Router A exports the aggregation data of different modes to 4.1.1.1, with UDP ports 2000, 3000,
•
4000, 6000, and 7000.
Figure 68 Network diagram
Configuration procedure
# Assign an IP address to GigabitEthernet 2/0/1.
<RouterA> system-view
[RouterA] interface gigabitethernet 2/0/1
[RouterA-GigabitEthernet2/0/1] ip address 3.1.1.1 255.255.0.0
# Enable NetStream for incoming and outgoing traffic on GigabitEthernet 2/0/1.
[RouterA-GigabitEthernet2/0/1] ip netstream inbound
[RouterA-GigabitEthernet2/0/1] ip netstream outbound
[RouterA-GigabitEthernet2/0/1] quit
# Specify the export destination host as 4.1.1.1 with UDP port 5000.
[RouterA] ip netstream export host 4.1.1.1 5000
# Configure the aggregation mode as AS, and specify the destination host for the aggregation data
export.
[RouterA] ip netstream aggregation as
[RouterA-ns-aggregation-as] enable
[RouterA-ns-aggregation-as] ip netstream export host 4.1.1.1 2000
[RouterA-ns-aggregation-as] quit
# Configure the aggregation mode as protocol-port, and specify the destination host for the aggregation
data export.
[RouterA] ip netstream aggregation protocol-port
[RouterA-ns-aggregation-protport] enable
[RouterA-ns-aggregation-protport] ip netstream export host 4.1.1.1 3000
[RouterA-ns-aggregation-protport] quit
# Configure the aggregation mode as source-prefix, and specify the destination host for the aggregation
data export.
[RouterA] ip netstream aggregation source-prefix
[RouterA-ns-aggregation-srcpre] enable
[RouterA-ns-aggregation-srcpre] ip netstream export host 4.1.1.1 4000
[RouterA-ns-aggregation-srcpre] quit
221