Show Traffic Control - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To configure the traffic log state on the Switch:
DGS-3620-28PC:admin# config traffic control log state enable
Command: config traffic control log state enable
Success.
DGS-3620-28PC:admin#
78-4 config traffic trap
Description
This command is used to configure whether storm control notification will be generated or not while
traffic storm events are detected by a SW traffic storm control mechanism.
Note: A traffic control trap is active only when the control action is configured as
shutdown. If the control action is drop there will no traps issue while storm event is
detected.
Format
config traffic trap [none | storm_occurred | storm_cleared | both]
Parameters
none - No notification will be generated when storm event is detected or cleared.
storm_occurred - A notification will be generated when a storm event is detected.
storm_cleared - A notification will be generated when a storm event is cleared.
both - A notification will be generated both when a storm event is detected and cleared.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a traffic control trap:
DGS-3620-28PC:admin#config traffic trap both
Command: config traffic trap both
Success.
DGS-3620-28PC:admin#
78-5

show traffic control

Description
This command is used to display current traffic control settings.
917