Replacing The Fuses - Thermo Scientific Accela PDA Hardware Manual

Replacing the Fuses

Thermo Scientific
You can operate the PDA detector at 100/115V or 230V. However, you must make sure that
the appropriate fuses are installed (see
Table 4. Fuses
Line power voltage
100/115V
230V
To replace the fuses
1. Turn off the power to the detector and unplug the detector from line power.
CAUTION To avoid an electrical shock, before you replace the fuses, turn off the
power to the detector and unplug the detector from line power.
2. Insert the tip of a narrow-blade screwdriver into one of the two openings on the exterior
surface of the power entry module, and then apply leverage to gain access to the power
entry module's door (see
Figure 78. Loosening the power entry module's door
Table 4).
Fuse size
T3.15 A
T1.6 A
Figure 78).
6
Routine Maintenance
Replacing the Fuses
Accela PDA Detector Hardware Manual 95