MIMAKI TS500P-3200 Operation Manual page 83

4
Remove the wiper.
• Pull out the wiper by holding the protrusions at its
both ends.
5
Clean the wiper and bracket.
• Wipe off the ink sticking to the wiper and bracket
with a clean stick dipped in cleaning solution for
maintenance.
Wipe off so that cleaning solution for maintenance
will not remain.
Wiper
6
Clean the wiper cleaner.
• Wipe off the ink sticking to the wiper cleaner with
a clean stick dipped in cleaning solution for
maintenance.
Wipe off so that cleaning solution for maintenance
will not remain.
7
Set the wiper at the original position.
• Insert the wiper by holding both ends of the wiper.
Projection
Bracket
wiper cleaner
8
Clean the cap rubber and cap rubber
cover.
• Wipe off the ink sticking to the cap rubber and cap
rubber cover with a clean stick dipped in cleaning
solution for maintenance.
Wipe off so that cleaning solution for maintenance
will not remain.
Cap rubber
9
Close the lower part of the right side front
cover then press the
• After its initial operation, the machine returns to
step1.
Performing the Station without
[FUNC2] (MAINT)
You can select Station by using the [FUNC1] (MENU) in
the Local without pressing the [FUNC2] (MAINT).
(1) Press the [FUNC1] (MENU) in Local.
(2) Press [][] to select "Maintenance", and press the
[ENTER] key.
(3) Press [][] to select "Station", and press the
[ENTER] key.
• The Station menu appears. Then proceed to step 2.
Chapter 4 Maintenance
Cap rubber cover
key.
4-9
4
2