MIMAKI TS500P-3200 Operation Manual page 117

Message
ERROR 186
HDC OVERFLOW [12 ]
ERROR 186
HDC UNDERFLOW [12 ]
ERROR 187
HDC SLEW RATE [12 ]
ERROR 188
HDC MEMORY [12 ]
ERROR 18a
Main PCB V_CORE
ERROR 18b
Main PCB V1R5B
ERROR 18c
Main PCB V12
ERROR 18e
FLS NOT COMP [12 ]
ERROR 18f
OFFSET START [12 ]
ERROR 18f
OFFSET END [12 ]
ERROR 19d
HDC V36 [12 ]
ERROR 201
COMMAND
ERROR 202
PARAMETER
ERROR 203
Ment Command
ERROR 206
PRINTING MODE
ERROR 304
USB INIT ERR
ERROR 305
USB TIME OUT
ERROR 306
USB GET DESC
ERROR 401
MOTOR X
ERROR 402
MOTOR Y
ERROR 403
X CURRENT
ERROR 404
Y CURRENT
ERROR 41B
** NO MEDIA **
ERROR 423
TAKE-UP TENSION-BAR
ERROR 424
FEEDING TENSION-BAR
Cause
Ink discharge control error
An error occurred in the main power.
Ink discharge control error
Abnormal ink discharge voltage was
detected.
Abnormal communication between PC and
printer
USB device error.
An excessive load was applied to the X
motor.
An excessive load was applied to the Y
motor.
An error due to an excessive current of the
X motor was detected.
An error due to an excessive current of the
Y motor was detected.
Media end
The media set check detected abnormality
of the take-up tension bar at the start of
printing.
The media set check detected abnormality
of the feeding tension bar at the start of
printing.
Chapter 5 Troubleshooting
Solution
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Check the USB cable/ LAN cable connec-
tion. Use a USB cable/ LAN cable con-
forming to the standard.
• Check the USB cable/ LAN cable connec-
tion. Use a USB cable/ LAN cable con-
forming to the standard.
• Check output conditions.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Set the media to cover over the media
sensors.
• Check the media set condition, and
remove any problem.
1
2
2
2
5
5-13