MIMAKI TS500P-3200 Operation Manual page 119

Message
ERROR 432
Take-UP Connect
ERROR 433
Feeding Connect
ERROR 436
Take-UP Fuse Err
ERROR 437
Feeding Fuse Err
ERROR 442
Take-UP Unit None
ERROR 443
Feeding Unit None
ERROR 447
CUTTER ENCODER ERR
ERROR 44d
STATION POS ERR
ERROR 468
Feed MTR ERR
ERROR 469
Take MTR ERR
ERROR 453
Take-UP Direction
ERROR 468
Feed MTR ERR
ERROR 469
Take MTR ERR
ERROR 505
MEDIA JAM
ERROR 50a
Y ORIGIN
ERROR 50c
MEDIA WIDTH SENSOR
ERROR 50f
L-SCALE BLACK
ERROR 510
THICKNESS DETECT
ERROR 516
MEDIA SET POSITION R
ERROR 516
MEDIA SET POSITION L
Cause
Take-up device connection destination
error
Feeding device connection destination
error
Take-up fuse blown
Feeding fuse blown
Take-up device missing
Feeding device missing
An abnormality occurred in the cutter
encoder.
An abnormality occurred in the station
position.
An abnormality occurred in the feeding
motor.
An abnormality occurred in the take-up
motor.
The take-up direction of the media that has
been set in the media take-up device is not
made to the specifications recommended
(face-out winding).
An abnormality occurred in the feeding
motor.
An abnormality occurred in the take-up
motor.
A media jam is occurred.
Y-origin could not be detected.
The media width has not been detected
correctly.
Abnormal linear scale.
A media thickness detection error is
occurred.
The media is set outside the proper area.
Chapter 5 Troubleshooting
Solution
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Please make the face-in winding direction
of the media.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Remove the jammed media, please re-
set the media.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Check the media set position.
• Clean the media sensor. (
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Entering the media thickness by manual
operation ( P.2-15), and detect the
media thickness again.
• Check the media set position.
1
2
2
P.4-3)
2
5
5-15