MIMAKI TS500P-3200 Operation Manual page 33

9
Raise the clamp lever at the front of this
machine.
• Temporary lock of the media is released.
10
Pull out the media.
• Holding both sides of the media, pull it out so that
the media top edge comes below the floor by
about 50cm.
• To set the media straight, pull out the media long.
11
Close the covers on the right and the left
sides of the feeding device at the back of
this machine.
• Close the covers and rock the cover.
12
At the back, lift the tension-bar down to the
stopper slowly to tighten the media.
(1) Pull the pin on the outside of the tension-bar
lock plate to unlock.
Pin
(2) Unlock the tension-bar, and then lift it down.
Tension-bar
lock plate
Tension bar
• Grip the outside of the tension-bar lock plate of the
tension-bar.
If gripping the other parts, your hand may get
stuck in.
13
Push down the clamp lever.
14
Adjust the position of the tension-bar with
the switches on the left of the feeding
device.
(1) Set the  switches to the take-up direction
of the media.
(2) Turn the left switch to [MANUAL].
(3) The tension-bar is lifted, reeling the media.
At this time, when the tension bar does not
move upward even if the media is fed,
change the  switch.
(4) When the tension-bar arm becomes parallel
to the floor, turn the left switch to [AUTO] to
stop the tension-bar.
(5) Turn the  switch to the feeding direction of
the media.
15
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
Media press
2
2
2
2
2-9