MIMAKI TS500P-3200 Operation Manual page 99

6
If there is no problem on the confirmation
screen, press the
• This resets the ink charge information embedded
in this machine.
7
Remove the ink tank cover.
• remove the screws (7 places) that is attached to
the ink tank cover, and remove the cover.
8
Remove the ink tank of the selected slot
and press the
(1) Press the protrusion on the lid of the ink tank
and remove the lid.
(2) Tilt the ink tank to the front and remove.
• Please be careful not to bend the tube by
tilting a tank too far.
(3) Wipe the tube that is attached to the lid with
the waste cloth etc., put the tube on the
outside of the balance.
9
Discard the ink in the ink tank selected in
step 4.
• When disposing of ink, call for service from our
company or our distributor.
• Request that an industrial waste disposal
company process the disposal ink.
10
Refer to P.4-28, and perform "Correct by
the correction method "Normal"" .
key.
key.
11
Replace the new ink tank.
• Cover the surrounding area with waste cloth for
protection against dirt before changing the ink
tank.
12
Refer to "Fill ink in the ink tank and
charging" on P.1-10, and refill with new ink.
Caution in handling of ink
• If you get ink in your eyes, immediately wash your
eyes with a lot of clean running water for at least
15 minutes. In doing so, also wash the eyes to
rinse ink away completely. Then, consult a doctor
as soon as possible.
• Use genuine ink tanks for this machine. This
machine functions by recognizing the genuine ink
tanks. In case of troubles caused by modified ink
tanks or the like, it shall be out of the warranty
even within the warranty period.
• If the ink bottle is moved from a cold place to a
warm place, leave it in the room temperature for
three hours or more before using it.
• Make sure to store ink bottles in a cool and dark
place.
• Store ink bottles and waste ink tank in a place that
is out of the reach of children.
• Request an industrial waste processor for
processing of empty ink bottles.
• Be sure to thoroughly consume the ink in the ink
bottle, once it is opened, within three months. If an
extended period of time has passed away after
opening the ink bottle, printing quality would be
poor.
• Do not shake ink bottles violently. This may result
in ink leakage from the ink bottles.
• Do not touch or stain the contacts of the IC chip.
This may cause damages on printed circuit
boards.
Chapter 4 Maintenance
4-25
4
2