Printing Data; Starting A Printing Operation; Stopping A Printing Operation; Deleting Received Data (Data Clear) - MIMAKI TS500P-3200 Operation Manual

Printing Data

Starting a Printing Operation

• When using a roll media, rewind the media by
hand before printing so that it is not loose.When
the roll media has not been rewound tightly, it may
cause the image quality to deteriorate.
• When the same data is printed, the color may
differ if print conditions are changed, including the
resolution, pass, scanning speed, and printing
direction. Check the effects before printing.
1
Setting a Media (
2
Checking the Heater Temperature
3
Press the
• If the heater temperature has not reached the
setting value,
"TEMPERATURE CONTROL" is displayed.
Even if it has not reached, you can move to
Remote when pressing the [ENTER] key.
• The screen changes to Remote, and data can be
received from the PC.
4
Transmit data to be printed from the PC.
• For the method of data transmission, see the
instruction manual for the output software.
Resolution Data type
VD : Variable data / ND : Normal data
REMOTE
540x360 VD
4/ B / x1 / W1 / ALL / R
Nozzle recovery information
R: Nozzle recovery is performed.
Select head
Waveform selection
W1 : WF1/ W2 : WF2
Scanning speed
x1 : Standard speed/ x2 : Double speed
Scan direction
U :Unidirectional / B : Bidirectional
Number of passes
2-20
P.2-4)
(REMOTE) key in LOCAL.
the worning message
The length of
0.0m
media printed
5
Start printing.
• The printing speed may change, depending on
the width of the set media or the position of the
print origin even when the same data is printed.
This is because of a difference in resolution.

Stopping a Printing Operation

Perform the following operation when stopping a printing
operation halfway.
1
Press the
• The printing operation stops.
• Interrupt data sending at the PC side during the
data is sent from the PC.
• Printing restarts from the interrupted data by
repressing the [REMOTE] key.

Deleting Received Data (Data Clear)

When you want to stop printing, delete the already
received data.
1
Press the
(DATA CLEAR) in LOCAL.
2
Press the
• The received data is erased then it returns to the
Local.
Behavior after printing has been
completed
Drying Feed
When printing has been completed, the feeding operation
is performed to dry the printed surface with the drying
heater.
• Perform the feeding operation until the back edge of print-
ing passes the drying heater.
• When you press the [END/POWER] key, the operation is
terminated.
• When the machine has been received next data continu-
ously, it will operate after the last data is received.
• Depending on the position of your drying fan, set the feed-
ing amount. ( P.3-20 "Setting a Drying Feed")
Screen display during drying feeding
(LOCAL) during printing.
key, and press the
key.
D r y i n g
P l e a s e Wa i t