MIMAKI TS500P-3200 Operation Manual page 32

3
Remove the roll holders.
• The roll holders are on both for the right and left of
the roll holder. Remove both with the procedures
below:
(1) Loosen screws (1 each on the right and left)
with supplied ratchet handle.
(2) Remove the holders.
4
Set a media on the roll shaft.
(1) Put the roll shaft through the paper core of
the media.
• Need to adjust the position of the paper core
to come in the middle of the roll shaft. Set the
media so as to align the scale of media set
label and the center position of the paper
core .
• Please be careful not to pinch your hand between
the paper tube and the roll shaft.
5
Put the roll shaft with the media on the
feeding device.
(1) Fitting the A part of the roll shaft to the B part
bearing of the machine, put it on.
B part
C part
• Carefully set C part so as not to hit near frame.
Scratches can cause malfunction.
(2) Close the cover.
(3) レバーをスライドさせてロックする
2-8
Ratchet handle
Roll holder
A part
• Put the shaft on gently, not roughly.
6
Open the front cover and raise the clamp
lever at the front of this machine.
Front cover
7
Slide the media from the back to the front.
• Insert the roll media between the platen and the
pinch roller, and slide it to the front.
• Pull the media out to the front of this machine with
enough length.
• When setting a media, be sure to cover the media
sensors located on the rear of the platen. The
media cannot be detected unless it is placed over
the sensor.
8
Push down the clamp lever from the back
of this machine.
• Lock the media temporarily.
Lever
Clamp lever