Table of Contents
Advertisement
Removing a hot-swap hard disk drive backplane
Use this information to remove a hot-swap hard disk drive backplane.
To remove the hot-swap hard disk drive backplane, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3.
Remove the cover (see "Removing the cover" on page 104).
Step 4.
Remove the filler panels from the drive bay.
Step 5.
Pull the hard disk drives out of the server slightly to disengage them from the hard disk drive
backplane (see "Removing hot-swap hard disk drives" on page 111).
Step 6.
Remove the hot-swap hard disk drive backplane.
a.
Carefully lift the backplane out of the chassis by pulling outwards and lifting it up.
Figure 58. Four 2.5-inch hot-swap-drive backplane removal
Step 7.
Disconnect all cables from the hard disk drive backplane.
If you are instructed to return the hard disk drive backplane, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing a hot-swap hard disk drive backplane
Use this information to replace a hot-swap hard disk drive backplane.
To install the replacement hot-swap hard disk drive backplane, complete the following steps:
Four 2.5-inch hot-swap-drive backplane
.
Chapter 5
Removing and replacing components
135
Advertisement
Table of Contents
Troubleshooting
