D-Link xStack DGS-3620 Reference Manual page 662

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
52-26 clear address_binding nd_snoop binding_entry ports
Description
This command is used to clear the ND snooping entries on specified ports.
Format
clear address_binding nd_snoop binding_entry ports [<portlist> | all]
Parameters
ports - Specifies the list of ports that you would like to clear the ND snoop learned entry.
<portlist> - Enter the list of port used here.
all - Clear all ND snooping learned entries.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear ND snooping entry on ports 1-3:
DGS-3620-28PC:admin# clear address_binding nd_snoop binding_entry ports 1-3
Command: clear address_binding nd_snoop binding_entry ports 1-3
Success.
DGS-3620-28PC:admin#
52-27 config address_binding dhcp_snoop_entry filename
Description
This command is used to configure the autosave state of DHCPv4 Snooping binding entries.
Note: This feature is only supported on devices that support external memory (e.g. SD
card).
Format
config address_binding dhcp_snoop_entry filename <path_filename 64> {autosave [enable
| disable]}
Parameters
<path_filename 64> - Enter the pathname, on the device's file system, to autosave the DHCPv4
Snooping binding entries.
autosave - (Optional) Specifies the auto-save state.
enable - Specifies that the auto-save feature will be enabled.
disable - Specifies that the auto-save feature will be disabled.
657