D-Link xStack DGS-3620 Reference Manual page 887

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
<area_id> - Enter the area ID value here.
metric - (Optional) Specifies a metric that will be advertised.
<value 1-65535> - Enter the metric value used here. This value must be between 1 and
65535.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create an OSPF host route:
DGS-3620-28PC:admin# create ospf host_route 10.48.74.122 area 10.1.1.1 metric 2
Command: create ospf host_route 10.48.74.122 area 10.1.1.1 metric 2
Success.
DGS-3620-28PC:admin#
76-11 config ospf host_route
Description
This command is used to configure an OSPF host route.
Format
config ospf host_route <ipaddr> {area <area_id> | metric <value 1-65535>}(1)
Parameters
<ipaddr> - Enter the host's IP address used here.
area - (Optional) Specifies a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the OSPF domain.
<area_id> - Enter the area ID value here.
metric - (Optional) Specifies a metric that will be advertised.
<value 1-65535> - Enter the metric value used here. This value must be between 1 and
65535.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure an OSPF host route:
DGS-3620-28PC:admin# config ospf host_route 10.48.74.122 area 10.1.1.1 metric 2
Command: config ospf host_route 10.48.74.122 area 10.1.1.1 metric 2
Success.
DGS-3620-28PC:admin#
882