D-Link xStack DGS-3620 Reference Manual page 462

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28PC:admin#show dvmrp
Command: show dvmrp
DVMRP Global State : Disabled
Interface IP Address
------------ -----------------
System 192.168.69.123
Total Entries: 1
DGS-3620-28PC:admin#
28-5 show dvmrp neighbor
Description
This command is used to display the DVMRP neighbor table.
Format
show dvmrp neighbor {ipif <ipif_name 12> | ipaddress <network_address>}
Parameters
ipif - (Optional) Specifies the IP interface name used for the display.
<ipif_name 12> - Enter the IP interface name used for the display here. This name can be up
to 12 characters long.
ipaddress - (Optional) Specifies the IP address and netmask of the destination used.
<network_address> - Enter the IP address and netmask of the destination used here.
If no parameter is specified, the system will display the whole DVMRP neighbor table.
Restrictions
None. (EI Mode Only Command)
Example
To display DVMRP neighbor table:
DGS-3620-28PC:admin# show dvmrp neighbor
Command: show dvmrp neighbor
DVMRP Neighbor Address Table
Interface
---------------
System
Total Entries : 1
DGS-3620-28PC:admin#
Neighbor Timeout
----------------
35
Neighbor Address Generation ID
---------------- -------------
10.48.74.123 86
Probe
-----
10
Expire Time
-----------
32
457
Metric State
------ --------
1 Disabled