D-Link xStack DGS-3620 Reference Manual page 198

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28PC:admin#
state enable
Command: config bgp neighbor route_reflector_client
Success.
DGS-3620-28PC:admin#
12-27 config bgp neighbor map
Description
The command is used to configure the route map related setting for a BGP neighbor. When a
route map is applied by the route_map command, it enforces the route policy. When it is applied
by the unsuppress_map command, the suppressed route which matches the permit rule will be
unsuppressed. It provides a manipulation of routers per neighbor. If a route map is configured
relating to a BGP neighbor but the route map doesn't exist, it means deny any. If the route map
exists but has no filter entry defined, it will permit all. By default, if both the IPv4 unicast and IPv6
unicast options are not specified, the setting is for the IPv4 unicast address family.
Format
config bgp neighbor map [<ipaddr> | <ipv6addr> | peer_group <peer_group_name 16>]
{[ipv4 | ipv6] unicast} {unsuppress_map [add | delete] <map_name 16> | route_map [in | out]
[add | delete] <map_name 16>}
Parameters
<ipaddr> - Specifies the IPv4 address of the neighbor to be configured.
<ipv6addr> - Specifies the IPv6 address of the neighbor to be configured.
peer_group - Specifies the peer group to be configured.
<peer_group_name 16> - Enter the peer group name here. This name can be up to 16
characters long.
ipv4 unicast - Specifies to configure the IPv4 unicast address family.
ipv6 unicast - Specifies to configure the IPv6 unicast address family.
unsuppress_map - (Optional) Name of a route map used to selectively advertise routers
previously suppressed by the aggregate_address command.
add - Specifies that a route map will be added.
delete - Specifies that a route map will be deleted.
<map_name 16> - Enter the unsurpress map name here. This name can be up to 16
characters long.
route_map - (Optional) Specifies the route map to be applied to the incoming or outgoing routes.
in - Specifies the incoming routes from the neighbor.
out - Specifies the outgoing routes sent to the peer.
add - Specifies that a route map will be added.
delete - Specifies that a route map will be deleted.
<map_name 16> - Enter the route map name here. This name can be up to 16 characters
long.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
config bgp neighbor route_reflector_client
193
10.10.10.2
10.10.10.2 state enable