D-Link xStack DGS-3620 Reference Manual page 567

Hide thumbs Also See for xStack DGS-3620:
Table of Contents

Advertisement

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
state - (Optional) Specifies if the multicast VLAN for a chosen VLAN should be enabled or
disabled.
enable - Enable multicast VLAN for the chosen VLAN.
disable - Disable multicast VLAN for the chosen VLAN.
replace_source_ip - With the IGMP snooping function, the IGMP report packet sent by the host
will be forwarded to the source port. Before forwarding of the packet, the source IP address in
the join packet needs to be replaced by this IP address. If none is specified, the source IP
address will use "0" IP address.
<ipaddr> - Enter the IP address here.
none - Specifies that the source IP address will not be replaced.
remap_priority - Specifies the remap priority here.
<value 0-7> - The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
none - If none is specified, the packet's original priority is used. The default setting is none.
replace_priority - (Optional) Specifies that the packet priority will be changed to the remap
priority, but only if remap priority is set.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure an IGMP snooping multicast VLAN with the name "v1", make ports 1 and 3 members
of the VLAN, and set the state to enable:
DGS-3620-28PC:admin#config igmp_snooping multicast_vlan v1 add member_port 1,3
state enable
Command: config igmp_snooping multicast_vlan v1 add member_port 1,3 state
enable
Success.
DGS-3620-28PC:admin#
45-3
create igmp_snooping multicast_vlan_group_profile
Description
This command is used to create a multicast group profile. The profile name for IGMP snooping
must be unique.
Format
create igmp_snooping multicast_vlan_group_profile <profile_name 1-32>
Parameters
<profile_name 1-32> - Specifies the multicast VLAN profile name. The maximum length is 32
characters.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
562

Advertisement

Table of Contents
loading

Table of Contents