D-Link xStack DGS-3620 Reference Manual page 1056

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config rip [ipif <ipif_name 12> | all] {authentication [enable <password 16> | disable] |
tx_mode [disable | v1_only | v1_compatible | v2_only] | rx_mode [v1_only | v2_only |
v1_or_v2 | disable] | state [enable | disable] | distribute_list_in [access_list <list_name 16> |
none]}(1)
Parameters
ipif_name - Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all - Specifies that all the IP interfaces will be used in this configuration.
authentication - (Optional) Specifies to set the state of authentication.
enable - Specifies that the authentication state will be enabled.
<password 16> - When the authentication state is enabled, enter the password used here.
This value can be up to 16 characters long.
disable - Specifies that the authentication state will be disabled.
tx_mode - (Optional) Specifies the RIP transmission mode.
disable - Specifies to prevent the transmission of RIP packets.
v1_only - Specifies that only RIP version 1 format packets will be transmitted.
v1_compatible - Specifies to transmit RIP version 2 format packets to the broadcast address.
v2_only - Specifies that only RIP version 2 format packets will be transmitted.
rx_mode - (Optional) Specifies the RIP receive mode.
v1_only - Specifies to receive RIP version 1 format packets.
v2_only - Specifies to receive RIP version 2 format packets.
v1_or_v2 - Specifies to receive both v1 and v2 packet.
disable - Specifies that the receiving of RIP packets will be prevented.
state - (Optional) Specifies that the RIP state will be enabled or disabled. If the state is disabled,
then RIP packets will not be either transmitted or received by the interface. The network
configured on this interface will not be in the RIP database.
enable - Specifeies that the RIP state will be enabled.
disable - Specifeies that the RIP state will be disabled.
distribute_list_in - (Optional) Specifies the inbound route filter on the RIP interface.
access_list - Specifies to use an IP standard access list to filter received RIP routes. If the
access list does not exist, the user can configure this successfully, but the function will not
take effective until the user created the access list. There is an implicit deny all rule at the
end of the access list. It will deny the receiving packets that does not match any previous
rules.
<list_name 16> - Enter the access list name. This name can be up to 16 characters long.
none - Specifies not to filter received RIP routes.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To change the RIP receive mode for the IP interface System:
1051