D-Link xStack DGS-3620 Reference Manual page 1012

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
87-2 config pfc willing
Description
This command is used to turn on the DCBX PFC willing option which indicates that the local 10G
port is willing to accept the PFC configuration from a remote system. Data Center Bridging
eXchange Protocol (DCBX) is used by DCB devices to exchange configuration information with
directly connected peers. The protocol may also be used for misconfiguration detection and for
configuration of the peer. The willing mode indicates that the local 10G port has been
administratively configured to accept configuration from the remote device.
Format
config pfc willing {ports [<portlist> | all]} [enable | disable]
Parameters
ports - (Optional) Specifies the 10G ports that will be used for this configuration.
<portlist> - Enter the 10G ports that will be used for this configuration here.
all - Specifies that all the 10G ports will be used for this configuration.
enable - Specifies to enable the PFC willing capability option.
disable - Specifies to disable the PFC willing capability option.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
This example shows how to enable the PFC willing option for port 26.
DGS-3620-28PC:admin#config pfc willing ports 1:26 enable
Command: config pfc willing ports 1:26 enable
Success.
DGS-3620-28PC:admin#
87-3 show pfc
Description
This command is used to display priority-based flow control information of an interface.
Format
show pfc {<portlist>}
Parameters
<portlist> - (Optional) Enter the 10G port list that will be displayed here.
If no port is specified, all 10G ports' information will be displayed.
1007