D-Link xStack DGS-3620 Reference Manual page 835

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
None.
Restrictions
None.
Example
To display SNMP:
DGS-3620-28PC:admin#show snmp
Command: show snmp
System Name
System Location
System Contact
SNMP Trap
SNMP State
SNMP Response Broadcast Request
DGS-3620-28PC:admin#
73-4 create trusted_host
Description
This command is used to create the trusted host. The switch allows you to specify up to 30 IP
addresses (or IP ranges) that are allowed to manage the switch via in-band SNMP or Telnet based
management software. These IP addresses must be members of the Management VLAN. If no IP
addresses are specified, then there is nothing to prevent any IP address from accessing the switch,
provided the user knows the Username and Password.
Format
create trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] {snmp | telnet | ssh | http | https | ping}
Parameters
<ipaddr> - Enter the IP address of the trusted host.
<ipv6addr> - Enter the IPv6 address of the trusted host.
network - Specifies the network address of the trusted network. The form of network address is
xxx.xxx.xxx.xxx/y.
<network_address> - Enter the network address of the trusted network. The form of network
address is xxx.xxx.xxx.xxx/y.
ipv6_prefix - Specifies the IPv6 network address of the trusted network.
<ipv6networkaddr> - Enter the IPv6 network address of the trusted network.
snmp - (Optional) Specifies the trusted host for SNMP.
telnet - (Optional) Specifies the trusted host for Telnet.
ssh - (Optional) Specifies the trusted host for SSH.
:
:
:
: Enabled
: Disabled
: Disable
830