D-Link xStack DGS-3620 Reference Manual page 582

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
IPv6 Link-Local Address
IPv6 Global Unicast Address : 2001::1000/64 (Manual)
IPv6 State
IP MTU
DHCP Option12 State
DHCP Option12 Host Name
IP Interface
Status
IP Address
Subnet Mask
Gateway
Link Status
Total Entries: 2
DGS-3620-28PC:admin#
46-7 enable ipif_ipv6_link_local_auto
Description
This command is used to enable the auto configuration of link local address when there are no
IPv6 addresses explicitly configured. When an IPv6 address is explicitly configured, the link local
address will be automatically configured, and the IPv6 processing will be started. When there is no
IPv6 address explicitly configured, by default, link local address is not configured and the IPv6
processing will be disabled. By enabling this automatic configuration, the link local address will be
automatically configured and IPv6 processing will be started.
Format
enable ipif_ipv6_link_local_auto [<ipif_name 12> | all]
Parameters
<ipif_name 12> - The name of the interface.
all - All of the IP interfaces.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the automatic configuration of link local address for an interface:
DGS-3620-28PC:admin#enable ipif_ipv6_link_local_auto interface1
Command: enable ipif_ipv6_link_local_auto interface1
Success.
DGS-3620-28PC:admin#
: FE80::2CD:8FF:FE65:B00/128
: Enabled
: 1500
: Disabled
:
: mgmt_ipif
: Enabled
: 192.168.0.1
: 255.255.255.0
: 0.0.0.0
: Link Down
577