D-Link xStack DGS-3620 Reference Manual page 917

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To delete an OSPFv3 virtual link:
DGS-3620-28PC:admin# delete ospfv3 virtual_link 1.1.1.1 60.60.60.60
Command: delete ospfv3 virtual_link 1.1.1.1 60.60.60.60
Success.
DGS-3620-28PC:admin#
77-20 show ospfv3 virtual_link
Description
This command is used to display OSPFv3 virtual link configurations. If no parameters are set, all
the virtual links will be displayed.
Format
show ospfv3 virtual_link {<area_id> <neighbor_id>}
Parameters
<area_id> - (Optional) Specifies a 32-bit number in the form of an IPv4 address that uniquely
identifies the OSPFv3 area in the OSPFv3 domain. This area is the transit area where the
virtual link is built.
<neighbor_id> - (Optional) Specifies a 32-bit number in the form of an IPv4 address that
uniquely identifies the OSPFv3 virtual neighbor in the OSPFv3 domain.
Restrictions
None. (EI Mode Only Command)
Example
To display an OSPFv3 virtual link:
DGS-3620-28PC:admin# show ospfv3 virtual_link
Command: show ospfv3 virtual_link
Virtual Interface Configuration
Transit
Area ID
--------------- --------------- -------- -------- ----------- ------
1.1.1.1
1.1.1.1
Total Entries: 2
DGS-3620-28PC:admin# show ospfv3 virtual_link 1.1.1.1 60.60.60.60
Virtual Hello
Neighbor Router Interval Interval
60.60.60.60 10
70.70.70.70 10
Dead Instance ID Link
60 0
60 0
912
Status
Down
Down