D-Link xStack DGS-3620 Reference Manual page 897

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
76-23 show ospf neighbor
Description
This command is used to display the OSPF-neighbor information on a per-interface basis.
Format
show ospf neighbor {<ipaddr>}
Parameters
<ipaddr> - (Optional) Specifies the IP address of the neighbor router.
If no parameter is specified, the system will display all OSPF neighbor information.
Restrictions
None.
Example
To display OSPF neighbor information:
DGS-3620-28PC:admin# show ospf neighbor
Command: show ospf neighbor
IP Address of
Neighbor
--------------- --------------- -------- -------------
10.48.74.122
Total Entries : 1
DGS-3620-28PC:admin#
76-24 show ospf virtual_neighbor
Description
This command is used to display the OSPF-neighbor information of OSPF virtual links.
Format
show ospf virtual_neighbor {<area_id> <neighbor_id>}
Parameters
<area_id> - (Optional) Specifies a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx)
that uniquely identifies the OSPF area in the OSPF domain.
<neighbor_id> - (Optional) Specifies the OSPF router ID for the remote area. This is a 32-bit
number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the remote
area's Area Border Router.
If no parameter is specified, the system will display all OSPF virtual-link neighbor information.
Router ID of Neighbor Neighbor
Neighbor Priority State
10.2.2.2 1 Initial
892