D-Link xStack DGS-3620 Reference Manual page 996

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
ethernet - Specifies the transport protocol of PTP as IEEE802.3 Ethernet.
udp - Specifies the transport protocol of PTP as UDP over IPv4.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To specify the transport protocol of PTP as IEEE802.3 Ethernet frames:
DGS-3620-28PC:admin# config ptp transport protocol ethernet
Command: config ptp transport protocol ethernet
Success.
DGS-3620-28PC:admin#
86-5 config ptp clock domain_number
Description
This command is used to configure the PTP clock common attribute of the domain number. The
domain number is used to identify the PTP domain that the PTP clock is working on. If the domain
number of the received PTP message is not identical to the domain number of the local device, the
PTP message shall be forwarded according to the multicast filtering configuration.
Format
config ptp clock domain_number <value 0-127> {unit <unit_id 1-12>} {domain_name <string
1-32>}
Parameters
domain_number - Specifies the domain attribute of the local clock. All PTP messages, data sets,
state machines, and all other PTP entities are always associated with a particular domain
number.
<value 0-127> - Enter the domain number used here. This value must be between 0 and 127.
The default value is 0.
unit - (Optional) specifies the domain number for a specified unit. If not specified, the domain
configurations applies to the local unit. If the unit is not present, the configuration is ignored.
<unit_id 1-12> - Enter the unit ID used here. This value must be between 1 and 12.
domain_name - (Optional) Specifies the domain name for a specified domain number.
<string 1-32> - Enter the domain name used here. This name can be up to 32 characters
long.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
991