Clear Bgp - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To create a confederation, AS number is 20:
DGS-3620-28PC:admin#
Command: config bgp confederation identifier 20
Success.
DGS-3620-28PC:admin#
12-33 config bgp confederation peers
Description
The command is used to configure multiple adjacent Autonomous Systems in a confederation. The
Autonomous Systems specified in this command are visible internally to the confederation. Each
Autonomous System is fully meshed within itself or configures route reflector.
Format
config bgp confederation peers [add | delete] <aspath_list>
Parameters
peers - Specifies that a peer will be added or deleted.
add - Specifies that a peer will be added.
delete - Specifies that a peer will be deleted.
<aspath_list> - Enter the AS number for BGP peers that will belong to the confederation
here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To add two confederation peers, AS number are 50000 and 50001:
DGS-3620-28PC:admin#
Command: config bgp confederation peers add 50000,50001
Success.
DGS-3620-28PC:admin#

12-34 clear bgp

Description
This command is used to initiate a hard reset or a soft reset for a connection. If a soft reset is
applied to the inbound session, the session will not be rebuilded but the local inbound routing table
config bgp confederation identifier 20
config bgp confederation peers add 50000,50001
199