D-Link xStack DGS-3620 Reference Manual page 318

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
packet - (Optional) Specifies to reset the OSPF packet counter.
neighbor - (Optional) Specifies to reset the OSPF neighbor event counter.
spf - (Optional) Specifies to reset the OSPF SPF event counter.
If the parameter is not specified, all OSPF counters will be cleared.
Restrictions
Only Administrator level users can issue this command.
Example
To clear all OSPF statistic counters:
DGS-3620-28PC:admin# debug ospf clear counter
Command: debug ospf clear counter
Success.
DGS-3620-28PC:admin#
20-17 debug ospf log state
Description
This command is used to enable or disable the OSPF debug log.
Format
debug ospf log state [enable | disable]
Parameters
state - Specifies the state of the OSPF debug log.
enable - Specifies that the OSPF debug log state will be enabled.
disable - Specifies that the OSPF debug log state will be disabled.
Restrictions
Only Administrator level users can issue this command.
Example
To enable the OSPF debug log:
DGS-3620-28PC:admin# debug ospf log state enable
Command: debug ospf log state enable
Success.
DGS-3620-28PC:admin#
313