D-Link xStack DGS-3620 Reference Manual page 1044

Hide thumbs Also See for xStack DGS-3620:

Table of Contents

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide

To display the Q-in-Q mode for ports 1 to 2:

DGS-3620-28PC:admin#show qinq ports

Command: show qinq ports 1-2

---------------------------------------------------------

Use Inner Priority:

Add Inner Tag:

---------------------------------------------------------

Use Inner Priority:

Add Inner Tag:

DGS-3620-28PC:admin#

create vlan_translation ports

This command is used to create translation relationships between C-VLAN and S-VLAN. This

setting will not be effective when the Q-in-Q mode is disabled. This configuration is only effective

for a UNI port. At the UNI port, the ingress C-VLAN tagged packets will be translated to S-VLAN

tagged packets by adding or replacing according the configured rule. The S-VLAN Tag of egress

packets at this port will be recovered to C-VLAN Tag or stripped.

create vlan_translation ports [<portlist> | all] [add cvid <vidlist> | replace cvid <vlanid 1-

4094>] svid <vlanid 1-4094> {priority <priority 0-7>}

<portlist> - Enter a range of ports on which the C-VLAN will be translated to S-VLAN.

all - Specifies to configure all ports.

add cvid - Specifies to add a S-tag before C-tag for incoming packets with a specific CVID.

<vidlist> - Enter the CVID (or list) to be matched for incoming packets.

replace cvid - Specifies to replace the original C-tag to a new S-tag for incoming packets with a

specific CVID.

<vlanid 1-4094> - Enter the CVID to be matched for incoming packets.

svid - Specifies the SVID of the S-tag to be added or replaced to the packets.

<vlanid 1-4094> - Enter the SVID between 1 and 4094.

priority - (Optional) Specifies a 802.1p priority of the S-Tag between 0 and 7. If the priority is not

specified, the 802.1p priority of the S-Tag will be assigned by the port's default priority or the

Chapters

Table of Contents