D-Link xStack DGS-3620 Reference Manual page 426

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To create a filter ICMPv6 RA All-nodes permit entry on port 5:
DGS-3620-28PC:admin#create filter icmpv6_ra_all_node permit sip 2200::5 ports
1:5
Command: create filter icmpv6_ra_all_node permit sip 2200::5 ports 1:5
Success.
DGS-3620-28PC:admin#
24-12 config filter icmpv6_ra_all_node log
Description
This command is used to enable or disable the filter ICMPv6 RA All-nodes log state.
Format
config filter icmpv6_ra_all_node log [enable | disable]
Parameters
enable - Specifies that the log for the filter ICMPv6 RA will be enabled. The log for filter ICMPv6
RA all-nodes will be generated.
disable - Specifies that the log for the filter ICMPv6 RA will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the filter ICMPv6 RA all-nodes log state:
DGS-3620-28PC:admin#config filter icmpv6_ra_all_node log enable
Command: config filter icmpv6_ra_all_node log enable
Success.
DGS-3620-28PC:admin#
24-13 config filter icmpv6_ra_all_node ports
Description
This command is used to configure the state of the filter ICMPv6 RA all-nodes packets on the
switch. The filter ICMPv6 RA all-nodes function is used to filter the ICMPv6 RA all-nodes packets
on the specific port(s) and receive the trust packets from the specific source. This feature can be
protected network usable when a malicious host sends ICMPv6 RA all-nodes packets.
Note: It only needs to filter the packet of which the destination address is the all-nodes multicast
address (FF02::1).
421