D-Link xStack DGS-3620 Reference Manual page 909

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config ospfv3 aggregation <area_id> <ipv6networkaddr> advertise [enable | disable]
Parameters
<area_id> - Specifies the OSPFv3 area's ID. It is a 32-bit number in the form of an IPv4 address
that uniquely identifies the OSPFv3 area in the OSPFv3 domain.
<ipv6networkaddr> - Specifies the IPv6 network address of the aggregation.
advertise - Specifies whether the OSPFv3 ABR will use this aggregation to aggregate the intra-
area routes or not.
enable - Specifies that the OSPFv3 ABR will use this aggregation to aggregate the intra-area
routes when it advertises these routes to another area.
disable - Specifies that the OSPFv3 ABR will not use this aggregation to aggregate the intra-
area routes when it advertises these routes to another area.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To configure an OSPFv3 area aggregation:
DGS-3620-28PC:admin# config ospfv3 aggregation 2.2.2.2 2000::/16 advertise
disable
Command: config ospfv3 aggregation 2.2.2.2 2000::/16 advertise disable
Success.
DGS-3620-28PC:admin#
77-12 show ospfv3 aggregation
Description
This command is used to display OSPFv3 area aggregation configurations.
Format
show ospfv3 aggregation {<area_id>}
Parameters
<area_id> - (Optional) Specifies the OSPFv3 area's ID. It is a 32-bit number in the form of an
IPv4 address that uniquely identifies the OSPFv3 area in the OSPFv3 domain.
Restrictions
None. (EI Mode Only Command)
904