D-Link xStack DGS-3620 Reference Manual page 531

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config gratuitous_arp send ipif_status_up [enable | disable]
Parameters
enable - Enable the sending of gratuitous ARP requests when the IPIF status becomes up.
disable - Disable the sending of gratuitous ARP requests when the IPIF status becomes up.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the sending of gratuitous ARP requests when the IP interface status becomes up:
DGS-3620-28PC:admin#config gratuitous_arp send ipif_status_up enable
Command: config gratuitous_arp send ipif_status_up enable
Success.
DGS-3620-28PC:admin#
41-6 config gratuitous_arp send periodically ipif
Description
This command is used to configure the interval for the periodical sending of gratuitous ARP
request packets.
Format
config gratuitous_arp send periodically ipif <ipif_name 12> interval <value 0-65535>
Parameters
<ipif_name 12> - Enter the interface name of the L3 interface. The maximum length is 12
characters.
interval - The periodically send gratuitous ARP interval time, in seconds.
<value 0-65535> - Enter the value between 0 and 65535. 0 (zero) means not to send
gratuitous ARP request packets periodically. By default, the interval is 0 (zero).
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the gratuitous ARP interval to 5 for the IPIF System:
DGS-3620-28PC:admin#config gratuitous_arp send periodically ipif System
interval 5
Command: config gratuitous_arp send periodically ipif System interval 5
526